Hello Brothers,
I have a problem with my General 350 Table Saw.
I just cleaned and lubed it. I set the tilt stops to make no contact with the stops. Despite that, I cannot get the blade tilt to reach 90°. I can only get it to 90.2°.
I have checked it and checked it again, the stops do not contact the bosses, and are not interfering with the range of motion!
What the heck is going on? There are no obstructions that I can identify... no caked sawdust, wood chips, burrs, etc.
This is a stock photo. Mine has the Excalibur fence system.
Reply Quote
I have a problem with my General 350 Table Saw.
I just cleaned and lubed it. I set the tilt stops to make no contact with the stops. Despite that, I cannot get the blade tilt to reach 90°. I can only get it to 90.2°.
I have checked it and checked it again, the stops do not contact the bosses, and are not interfering with the range of motion!
What the heck is going on? There are no obstructions that I can identify... no caked sawdust, wood chips, burrs, etc.
This is a stock photo. Mine has the Excalibur fence system.
Reply Quote
