Post a photo of the last thing you turned

[Chris152]

Here is my first (successful) natural edge bowl, pretty pleased with it despite a few areas of tear out (which are barely noticeable unlike in the pictures).
I didn't dare going any thinner due to my previous failed attempt.

Lovely grain, not entirely sure of the type of oak; the log came from an evergreen tree, if it helps.


View attachment 189178View attachment 189179View attachment 189180View attachment 189181View attachment 189182View attachment 189183View attachment 189184View attachment 189185View attachment 189186

That'll be holm oak. Beautiful, somewhat splitty and very hard.

 

[Katomi woodsmith]

I use coffee granules as well.....to make a cuppa lol

 

[Katomi woodsmith]

I like the natural edge bowl, I don’t think my skill in woodturning is that level yet so it will be a while before I try

 

[Stigmorgan]

I like the natural edge bowl, I don’t think my skill in woodturning is that level yet so it will be a while before I try

It's not so different from a flat rimmed bowl unless the live edge is extremely wavey. Feel free to come over for some practice, I've loads of Lime blanks you can practice on

 

[kinverkid]

I have a piece ready cut 45mm x 60mm but also have another 15mmx55mm which of you wished you could glue them together for free. Otherwise I would have to cut from a larger piece but would cost £30 + P&P.

 

[Stigmorgan]

I have a piece ready cut 45mm x 60mm but also have another 15mmx55mm which of you wished you could glue them together for free. Otherwise I would have to cut from a larger piece but would cost £30 + P&P.View attachment 189421

I'll pass for now, the glued section would likely come off during use and I don't have funds at the minute, have to find the cash to pay my shop rent for this month. Thank you for looking though I really do appreciate it

 

[kinverkid]

You're welcome

 

[Katomi woodsmith]

Nice piece of wood what are they?
Someone here gave me advice on my out of balance bowl, can’t find the thread now
However, thank you, I did look at the alignment and it’s spot on thank you .
Just had a play with an idea I wanted to try, I wanted two coloured lines on the edge of a bowl
Images
Below.. thoughts and comments are welcome

 

[Stigmorgan]

Nice piece of wood what are they?
Someone here gave me advice on my out of balance bowl, can’t find the thread now
However, thank you, I did look at the alignment and it’s spot on thank you .
Just had a play with an idea I wanted to try, I wanted two coloured lines on the edge of a bowl
Images
Below.. thoughts and comments are welcome

They are ebony.

Here's a little hammer i just finished made from brass, hawthorne and ebony finished with friction polish

 

[pat from Marck]

They are ebony.

Here's a little hammer i just finished made from brass, hawthorne and ebony finished with friction polish
View attachment 189449View attachment 189450View attachment 189451View attachment 189452View attachment 189453

Very nice idea for that discarded inline filter

 

[Stigmorgan]

Very nice idea for that discarded inline filter

That ones just a little T junction, the inline filter is a lot bigger

 

[pat from Marck]

The cherry burl saga
Today was spend hand sanding the big odd shaped bowl, still have a load more to do tomorrow but its getting there. To break up the sanding I spent the odd interval working on completing the small lidded bowl. Steph thinks its the best so far.