/*
Blink
Turns an LED on for one second, then off for one second, repeatedly.
Most Arduinos have an on-board LED you can control. On the UNO, MEGA and ZERO
it is attached to digital pin 13, on MKR1000 on pin 6. LED_BUILTIN is set to
the correct LED pin independent of which board is used.
If you want to know what pin the on-board LED is connected to on your Arduino
model, check the Technical Specs of your board at:
Arduino Hardware
modified 8 May 2014
by Scott Fitzgerald
modified 2 Sep 2016
by Arturo Guadalupi
modified 8 Sep 2016
by Colby Newman
This example code is in the public domain.
Blink
*/
#define LIGHT 13; // change for the i/o pin you are using
// the setup function runs once when you press reset or power the board
void setup() {
// initialize digital pin LIGHT as an output.
pinMode(LIGHT, OUTPUT);
}
// the loop function runs over and over again forever
void loop() {
digitalWrite(LIGHT, HIGH); // turn the LED on (HIGH is the voltage level)
delay(1500); // wait for 1.5 seconds
digitalWrite(LIGHT, LOW); // turn the LED off by making the voltage LOW
delay(1500); // wait for 1.5 seconds
digitalWrite(LIGHT, HIGH); // turn the LED on (HIGH is the voltage level)
delay(1500); // wait for 1.5 seconds
digitalWrite(LIGHT, LOW); // turn the LED off by making the voltage LOW
delay(1500); // wait for 1.5 seconds
digitalWrite(LIGHT, HIGH); // turn the LED on (HIGH is the voltage level)
delay(1500); // wait for 1.5 seconds
digitalWrite(LIGHT, LOW); // turn the LED off by making the voltage LOW
delay(30000); // wait for 30 seconds
}
