What connector is this?

[Fergie 307]

The problem is the tabs either side, if they are how it is secured, as I suspect, then a normal fork isn't going to work, nor will it be easy to modify any standard fitting. Probably a bespoke part. I would be very surprised if they will sell you just the connector. Probably be a new one of whatever is on the other end !
I think you may well end up having to make one.

 

[Mead Camans]

Thanks for the input all. I've included some pictures of the connection port and the connector in place. It sits in at a 90 degree angle, which makes it a bit delicate to remove without bending it.

Record say they'll supply a replacement length of wire with a connector, so hopefully will be all good.

George

 

[joncooper27]

That’s exactly the same as my Karcher motor connection

 

[flying haggis]

At least if it came to it there is nice copper to solder to...

 

[Mead Camans]

UPDATE:

Ok having received a replacement motor, I see the issue. The connector in question isn't meant to be disconnected. On the other end, there's a standard connector that removes much easier. It never occurred to me to check and disconnect the other end of the wire! Lesson learned.