Deadeye
Established Member
I'm making some door panels and need to halve some 230x32mm (section) timber.
I've planed both sides, so it's now just over 29mm, and I'd really like to get 12mm panels...so trying to get a kerf and two planed faces out of my last 5mm!
Any tips to keep the blade from drifting?
I could cut a tablesaw groove each side - I can get just under 90mm each side. Would the groove help direct the bandsaw blade? My tablesaw blade takes 3.2mm so really can't scuff the faces much with the bandsaw.
Thanks!
I've planed both sides, so it's now just over 29mm, and I'd really like to get 12mm panels...so trying to get a kerf and two planed faces out of my last 5mm!
Any tips to keep the blade from drifting?
I could cut a tablesaw groove each side - I can get just under 90mm each side. Would the groove help direct the bandsaw blade? My tablesaw blade takes 3.2mm so really can't scuff the faces much with the bandsaw.
Thanks!