Odd T-track size bits needed

[nickds1]

Hi

Just doing a some minor refurb on a Kity 1619 saw, and its missing a couple of small bits. I also want to adapt some other bits for use on the tracks milled into the top...

These are an odd size, being 15mm on the top, 19mm at the base and about 5.5mm deep - see the attached drawing...

Any idea on where I can source some bar to fit these tracks would be great - I could machine some myself, but it'd be a fair bit of pain!

Many thanks

 

[MikeJhn]

Ikea cutting boards are ideal as sliders cut to size, find the tongue at the bottom of a slider is a pain as you have to slide whatever it is off the end of the table to lift it.

 

[nickds1]

I need to clamp some fences to the table, hence the need for t-nuts that fit. If it was just a slide, it'd not be an issue...

 

[MusicMan]

If you search T-nuts you may find the right size.