pgrbff
Established Member
Is there an alternative to paying a small fortune for an abrasive cleaning stick as used on belt sanders and stationary disc sanders?
Cleaning abrasives
- Thread starter pgrbff
- Start date
Help Support UKworkshop.co.uk:
Jacob
What goes around comes around.
pgrbff
Established Member
Looks good but....
My mum born Chesterfield but we both live in Italy now.
I think the Silverline was over 12 euro on Amazon.it
My mum born Chesterfield but we both live in Italy now.
I think the Silverline was over 12 euro on Amazon.it
Inspector
Nyuck, Nyuck, Nyuck!
Find some Crepe soled shoes. Same stuff. My buddy wore Hush Puppies for years and all his old ones ended up beside the belt sander. Another soft rubber type might work. A new use for Crocs perhaps.
Pete
Pete
Distinterior
Established Member
Artificial cork from wine bottles works well....but you may need quite a few of them depending on how many abrasives you need to clean! 
It shouldn't be a problem for you finding them in Italy though....
It shouldn't be a problem for you finding them in Italy though....
Robbo3
Established Member
+1 for cured silicone sealant.
Orraloon
Established Member
I just found 2 old unused tubes that have gone hard so will give it a go. Up to now I have just used old shoe soles or rubber mat offcuts. I have a feeling that just about any rubbery compound will do the job. The mat offcuts were black and still cleaned the belts or discs.
Regards
John
Regards
John
Henniep
Established Member
Try the back end of an old tooth brush. Some types work, some don't.
steve66
Established Member
Rolled up plastic bag will clean belts as well
John on the Wirral
Established Member
If you don't let the abrasive too clogged switch it on and run a wire brush across it
Ashcraftwoodturning
Member
UPVC tubing/extrusions work well
+1 for artificial wine corks. Best for a smaller disk
Phil Pascoe
Established Member
+2
i do this. works OK.
Richard_C
Established Member
Never considered artificial wine "corks", had one in the box of bits by the sander and just tried it, works a treat. No doubt the other suggestions are as good, but I drink wine more often than I clean abrasive discs so no need to expend any more thought.
Yes Steve - got this tip from an old buddy years ago - it works REALLY well (especially if you twist and knot, twist and knot, the bag into a 'rope') ...
Robbo3
Established Member
To answer several of the replies above:
• A wire brush will clean the abrasive but will also help wear it away whereas silicone just cleans out the crud.
• A rolled up plastic bag also works but doesn't last like silicone & is harder to control.
• A wire brush will clean the abrasive but will also help wear it away whereas silicone just cleans out the crud.
• A rolled up plastic bag also works but doesn't last like silicone & is harder to control.
Inspector
Nyuck, Nyuck, Nyuck!
My hesitation using hardened silicone caulk is that silicone in lubricants and spray wax polish that gets on wood may cause fish eyes or other finishing problems. So I don't use them in my shop at all. They can even migrate from one machine surface to another and cause issues. I wonder if impeded silicone rubber bits in wood can cause finishing issues later? Until I know for sure I won't use cured silicone to clean sanders and I have a number of old silicone casting molds that could potentially do the job too. Any finishing experts know for sure one way or another?
Pete
Pete
I use hardened silicone caulk tubes as well. Rather than discarding them, give it a go. They work well-enough...
