Axminster / Kufo sk 250ts-l panel saw Help?!

[J A Hathaway]

Hi all, new to the site but looking for some advice.

I recently got hold of a second hand Axminster sk250ts-l from 2003 this was as I've found out was produced by Kufo for Axminster.

The saw I have is missing the fence, table extensions and the sliding panel saw assembly. luckily the rest of the saw is great!

I have contacted Axminster and managed to get the original manual and diagrams however not surprisingly they don't have any of my missing bits.

As I understand it Kufo still produce this saw however I can't seem to find anywhere in the uk that deals Kufo. Does anyone know anywhere that does?

Does anyone have any sk250ts-l parts?

Here are some pictures the saw

 

[J A Hathaway]

This is a saw that's currently on eBay, just to show a comparison of what it should look like.

 

[J A Hathaway]

Is anybody able to help? Know if anyone who might be able to help?

Thanks

John

 

[Sk-woods]

Hello,
Is it possible to post the original diagram and manual, I have been looking for it for a good hour and can not find it anywhere, if possible it will be much appreciated
Thank you

 

[rgrfr]

Hi all, new to the site but looking for some advice.

I recently got hold of a second hand Axminster sk250ts-l from 2003 this was as I've found out was produced by Kufo for Axminster.

The saw I have is missing the fence, table extensions and the sliding panel saw assembly. luckily the rest of the saw is great!

I have contacted Axminster and managed to get the original manual and diagrams however not surprisingly they don't have any of my missing bits.

As I understand it Kufo still produce this saw however I can't seem to find anywhere in the uk that deals Kufo. Does anyone know anywhere that does?

Does anyone have any sk250ts-l parts?

Here are some pictures the saw

We also have the Axminster sk250ts-L and I've attached some of the parts list should anyone need it.
I think the table saw is made by BAPILON in Taiwan; sold by KUFO (Santa Fe) and others that we can't find.
Our sliding table sk250ts-L needs some bearing parts to fix it (photo below). These are referenced as NR5 in the manual. I'd call them 5mm flat plastic caged needle roller bearings and we need 12 of them.

Axminster told us that at 12 years old we're asking for too much (which I feel is shabby of them). So we are stuck seeking a spare. Should anyone have some ideas or advice do please reply.