popuppete
Member
Hi all,
I just wondered if it is possible to change the plastic winder for the tail stock & getting one that has a handle to turn the tail stock pin ( please excuse not knowing the correct name for it) in and out, as I find the plastic wheel a bit slippery.
Is there anything I can such as getting a different tool rest, or is there anyway of tightening the supplied one?
I ask because I spent a very pleasant 4 hours in my shed, turning a piece of pine into the shape of the top of a wine
I haven't turned the inside yet but will try tomorrow. It was good practise using my carbide chisels, I also tried a couple of my traditional chisels. One of which I had to make a handle for.
I just wondered if it is possible to change the plastic winder for the tail stock & getting one that has a handle to turn the tail stock pin ( please excuse not knowing the correct name for it) in and out, as I find the plastic wheel a bit slippery.
Is there anything I can such as getting a different tool rest, or is there anyway of tightening the supplied one?
I ask because I spent a very pleasant 4 hours in my shed, turning a piece of pine into the shape of the top of a wine
