Search results

Thanks for all the advice; I will be implementing many of the suggestions doubleb; Is that the regular or large Veritas Front Vice

Bodger :oops: You do get some extra drill bits too :lol:

Here and Here should get you going That is what I am considering

At long last I have decided to build a work-bench in my garage; to be based on This All Redwood; the top to be 3 x 2 on edge, perhaps with 1 inch MDF screwed on top; 68" x 22" overall It does not have an Apron and top is only connected with 6 ragbolts is that OK ? Cross supports to legs are...

:roll: Naz (hammer) LOL !

Coley, do you qualify for a pay-out ?

Good luck Geoff and Bon Voyage :) :D Not visited the Philippines; but spent a couple of years nearby in Indonesia in my younger years

The tight Hairpin bend in your hose is a killer; needs to be as straight as possible

Look here

BLAG Robust handsome table and seats there; excellent =D> :)

Inspiring words there Custard As a novice I needed a whole afternoon to fit the back slats to this Adirondack -- only took 20 seconds for Norm

:( :( :oops: ....but I want one

Cheers ED65 Looking at this on Inkscape suggests the angle is 65 degrees Butt joints; is that my excuse to buy a Festool Domino 500 ? Might be a costly table :roll: Using a home-built jig I made some mortise and loose tenon joints but tedious and fiddly with a router; needs lots of...

I would like to make this However...... As a novice I don't know where to start more photos

Ordered the Wealdon Dart as per Oakmitre at 10- 30 Thursday night Arrived Saturday morning; good product, job sorted :lol:

Cheers Erik Saw the add on *bay; sadly no friends with a lathe Oakmitre thanks for Wealdon link; Ordered one of those Got the idea from George at one minute

=D> Cool Naz =D>

Looking for a source for half inch diameter router cutter with tip like a dart To fit in my plunge router to get good central position on the wood; then swap to standard cutter to do the biz I've seen them on USA you-tubes but can't find any here Any info much appreciated

MattR The bit that I have is for a half inch router Been using it today to route mortise holes into Walnut

Skeeter this was recommended here a while back I got one and it's great; mine is used to cut mortises; so same as what you want, ie drilling holes but not all the way through. hope this helps