Up and running

UKworkshop.co.uk

Help Support UKworkshop.co.uk:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
All running fine :D Thanks for all the help . I have nine oak shaker doors to make this week so i had to get it sorted .
 
Scrit , can i ask why you have put spacers on the spindle rather than taking the nut all the way down to the top hat on the saw blade ?
 
JFC":1nzqcmi0 said:
Scrit , can i ask why you have put spacers on the spindle rather than taking the nut all the way down to the top hat on the saw blade ?
It's just quicker than winding the nut down the whole way. In any case with smaller blocks the thread doesn't run down far enough.

Scrit
 
Well back on the spindle today and i've made my dust extraction and safety cover as well as the sacrificial fence . :D
I didn't like the idea of holding the fence and pushing it into the block to get the cut out as my fence runs on two bolts , if it snagged there would be metal flying every where :shock:
DSC00086.jpg
 
JFC":dj6p0uu2 said:
I didn't like the idea of holding the fence and pushing it into the block to get the cut out as my fence runs on two bolts , if it snagged there would be metal flying every where :shock:

So how did you do it in the end, or are you just saying you didn't like it.
 
:lol: I had to make it that tall to incorporate the workings for the pressure clamps . Its not that far of the one scrit made . It works very well :D
I just drew around the block and cutter , much safer and less scarey :oops:
 
JFC":1xlm792j said:
I just drew around the block and cutter , much safer and less scarey :oops:

:lol: :lol: :lol: where do you store your cutters, in your handbag :lol:
 
Jason, whilst using the spindle you might find it safer if you put on this new safety feature.














15c2wo2.jpg

Although I'm not sure it will go with your handbag :lol: :lol:
 

Latest posts

Back
Top