Union Graduate

[Bills Elm]

Al,

I'll have to get back to you tomorrow on that. I'll have a look see then and tell you the info many thanks again for all your help I appreciate it!!

 

[YewTube]

Bill

Regarding the voltages on your motor. You should read the voltage section of this http://www.csanyigroup.com/general-about-motors. Depending on how they are wired they can be different voltages. Your eBay link is saying that you need a delta connection. You can achieve this by moving the wires around in the terminal block. If you don't understand either phone the eBay supplier or get a local electrician to look at it.

Best of luck

Bill

 

[Dangermouse]

You could get a second hand single phase motor, as long as it does not have a centrifugal switch ring, and buy one of these. They are very very helpful on the phone. So give them a ring and see what they say.

http://www.ebay.co.uk/itm/POWER-VOLTAGE ... 565018076c

 

[flh801978]

You could get a second hand single phase motor, as long as it does not have a centrifugal switch ring, and buy one of these. They are very very helpful on the phone. So give them a ring and see what they say.

http://www.ebay.co.uk/itm/POWER-VOLTAGE ... 565018076c

This is only for a brush motor speed control application you dont want one of those on a graduate.!!!

Ian

 

[Bills Elm]

Thanks for all the help guys It's much appreciated!!

I just aquired a dual voltage graduate motor for £40 so I'm now able to switch to Delta and run an inverter on 220 volts.

Well pleased and thanks again all!!

Cheers Bill