SP
Established Member
I got this router recently and so far have been extremely pleased.
Today though it twice allowed a 1/4" bit to rise out of the collet and cause the cut to be too deep (router under table).
It was the cutter that moved, not the 1/4" sleeve and yet I had tightened it hard.
Has anyone else had this problem?
Is it possible to get a proper 1/4" collet for the Triton?
Thanks for any help,
Stephen
Today though it twice allowed a 1/4" bit to rise out of the collet and cause the cut to be too deep (router under table).
It was the cutter that moved, not the 1/4" sleeve and yet I had tightened it hard.
Has anyone else had this problem?
Is it possible to get a proper 1/4" collet for the Triton?
Thanks for any help,
Stephen