Struggling

[Nelly111s]

This lathe looks the same as the Jet 1014. Has the lathe got a small turned knob on the back of the headstock that is sprung loaded to help it remain out? It's also threaded to push in an locate into holes inside the headstock and provide a spindle lock. The tailstock / drive centre looks identical to the Jet 1014 (I have 8 of them).

 

[Garno]

This lathe looks the same as the Jet 1014. Has the lathe got a small turned knob on the back of the headstock that is sprung loaded to help it remain out? It's also threaded to push in an locate into holes inside the headstock and provide a spindle lock. The tailstock / drive centre looks identical to the Jet 1014 (I have 8 of them).

I will have to have a look tomorrow, I am going to give it a good clean and put some PTFE dry on it.