Safety Gloves

[niemeyjt]

Who wears them in the workshop - always / sometimes / never?

Issues - what do people think of issues of sepsis safety vs loss of grip and sensations?

So, what do people think? Recommendations?

 

[Orraloon]

Sometimes would be my answer. I use gloves for a few things but they are not safe around woodworking machines. Spinning cutters can catch the glove and pull your whole hand in. Same goes for loose clothing or anything else that can get caught. Think about the job you are about to do and whether gloves will help or make things worse.
Regards
John

 

[Bumble]

I wear gloves in the winter but this is because it's minus eight degrees and just touching steel tools is like handling a ball of red hot needles! I need to take them off and put them on again for perhaps seventy percent of tasks; I find bare hands are needed for dexterity and sensation for those.

I use gloves with very thin rubber on the palm side and a breathable fabric on the back of the hand.
Not dissimilar to these

The jack russell that is the trimmer/router tried to bite my finger once; luckily it was one of the times I was wearing the gloves and mostly all it got was a mouthful of rubber.

 

[Seascaper]

Hello,
I often wear a pair of leather close fitting gardening gloves, especially when drilling metal. I have cut myself several times on the metal when brushing aside the swarf.
I can well recommend them.
Regards

 

[Bingy man]

Depends on the job in hand , biggest issue for me is most cause my hands to sweat which is not pleasant or healthy. I learned from an early age that cold steel in the middle of winter is not kind to your skin so waterproof and breathable are important. A recent thread about using gloves / woodworking machines a member recommended dirty rigger gloves which left the thumb, fore finger and index fingers uncovered but the rest of the hand covered so again dexterity is important picking up screws , and nails or using a pencil. I like this design and have a pair for rough work and a pair for clean ( workshop use )

 

[kinverkid]

Depends. I wear gloves similar to Bumble's above most of the time. I have neuropathy in my fingertips so a loss of feeling from wearing them is not an added problem. I'm used to wearing them and I keep a pair in most jackets and aprons. I now keep tweezers in various locations around the workshop (like some of us do with pencils) to make handling fiddly bits easier. Also, touching something cold is like holding a frozen turkey for a couple of days a week after my medication day so they are also for comfort. I wear rubber-faced Kevlar-type gloves for handling used/rough timbers like pallets and anything with nails protruding. I have also had close calls while wearing them where the glove suffered rather than my hand.