Hi,
I’m looking for a bit of advice on dust extraction.
I have an Axminster canister dust extractor that’s incredibly loud and a screwfix titan vacuum, which is a little champion but its plastic construction is wearing out.
I’m thinking of replacing both with something better and was looking for some advice
Tools: table saw (old cheap Axminster one with pants dust extraction design), bandsaw with dust extraction port at the bottom, thickness planer, and variety of tools that accept a vacuum port
I’m not sure what would be better - something like this:
https://www.turners-retreat.co.uk/compact-extractor-single-motor-36ltr/p1430 (the quiet mode is a bonus and its compact good for my small shop)
Or a vacuum linked in series with a cyclone
https://www.myhenry.com/charles-cvc370
https://www.amazon.co.uk/Wet-Dry-Va...hvtargid=pla-2275918497520&psc=1&gad_source=1
Cheers
I’m looking for a bit of advice on dust extraction.
I have an Axminster canister dust extractor that’s incredibly loud and a screwfix titan vacuum, which is a little champion but its plastic construction is wearing out.
I’m thinking of replacing both with something better and was looking for some advice
Tools: table saw (old cheap Axminster one with pants dust extraction design), bandsaw with dust extraction port at the bottom, thickness planer, and variety of tools that accept a vacuum port
I’m not sure what would be better - something like this:
https://www.turners-retreat.co.uk/compact-extractor-single-motor-36ltr/p1430 (the quiet mode is a bonus and its compact good for my small shop)
Or a vacuum linked in series with a cyclone
https://www.myhenry.com/charles-cvc370
https://www.amazon.co.uk/Wet-Dry-Va...hvtargid=pla-2275918497520&psc=1&gad_source=1
Cheers
