Inca Major 341 table alignment

[tlwolf]

My Inca Major 341 saw table is about 1- 2 mm out of square with the blade. I cannot figure out how to make this adjustment. Have not found any adjustment instructions. The only bolts I have located are the 3 on each side of the table that attach it to the tilt half wheels (part 57.04.0237). Loosening theses does not seem to allow for any adjustment. Any advice would be appreciated. Thanks

 

[Deadeye]

I'm a bit confused. Are you saying that the tilt trunnions do not allow adjustment to fully horizontal?