I'm at it again

[devonwoody]

The wife needed a frame for that kingisher:

I did need a paper thin veneer piece to close the gap. :wink:

 

[Waka]

DW

Thats fantastic needle work and the frames not bad either.

Did you hand cut the mitres?

 

[devonwoody]

Waka, it was cut with the sliding table on the scheppach2500ci. and the fit up at the end required a .5mm shaving to close the gap. I think this can be improved on the next time by using a clean wooden stop on the sliding arm. I think a mitred end point most probably crept under the aliminum stop arm that comes with the scheppach.

 

[DaveL]

Nice looking frame Devon, but I am waiting to see that saw of yours in the kitchen as you seem to work there more than in the shop! :wink:

 

[devonwoody]

Actually the wife lets me bring in my japanese saw