How to make precision cuts

[colinvansmith]

Hi all,

I have a project im working on at the moment. I have 300 pieces of wood which measure 10mm x 10mm x250mm. I'm trying to cut these into 10mm x 10mm x10mm cubes but having difficulty making accurate cuts. When I use my electric compound mitre saw, the little pieces ping away once cut and are difficult to find and when I try and do them by hand, it takes a long time and sometimes my cuts aren't straight so it's not a perfect little cube. Can anyone give me some ideas of the best way to cut these into cubes.

Many thanks,

Col

 

[ChaiLatte]

Your question goes in two directions. With the mitre saw, you do not say if the cuts are acceptable, only that the pieces disappear.

Buy one of these:

https://www.amazon.co.uk/DIVCHI-Tier-Greenhouse-Vegetables-Seedlings/dp/B0D8LC6LV9

Cut two holes in the front flap for your arms and the pinging will be confined to a finite area. Count in your head every time you make a cut and then you know how many cubes you need to retrieve.

You do not have to cut all 300 pieces individually. Tape a few together into a bundle. A 5 x 5 square reduces the count to 12 pieces and even without the tent, all 25 cut off pieces are not going to escape.

 

[Blackswanwood]

I’d hold 5 pieces together flat using parcel tape on the underside. The cubes would then be less likely to fly/easier to locate as they should stay connected when you make the cut.

If you are struggling to make the cuts accurately by hand make a simple mitre box or guide that you can hold the saw against …

https://www.flinn-garlick-saws.co.u...dXV_UW9IYXRtMSJu73SsP5LSvzu9IAcBoC05sQAvD_BwE

 

[Keithgrif]

1) Set up a sacrificial fence at the back, to ensure proper support for the piece
2) zero clearance slot on the base. Alternatively another sacrificial fence - combine the two fences into one L shaped. ( Don't cut all the way though the base of course)
3) Use a stop block for accurate size and repeatable cuts. If you place the block for a longer cut and add a screw in the face towards the cut you can fine tune the stop block position.

Hope that helps.

 

[HOJ]

Another tip when you make small cuts like this DONT lift the blade until it has stopped spinning, small offcut parts get picked up by the blade and flung around if you lift it out.