syntec4
Established Member
I had this happen on Saturday Whilst cutting some grooves on the router table. The bit is (was) a 6mm. It's a Trend one. I think it was a new one, although I have had it a while. I was lucky the bit stayed in the box of the router table.
I was only cutting a slot 4mm deep and using a slow feed rate. the bit broke just after I started too, so I don't think it was heat build up.
Could there be something else I'm doing wrong? I was cutting 12mm birch ply at the time.
Cheers
Lee.
I was only cutting a slot 4mm deep and using a slow feed rate. the bit broke just after I started too, so I don't think it was heat build up.
Could there be something else I'm doing wrong? I was cutting 12mm birch ply at the time.
Cheers
Lee.