Changing drive belt on Lurem combi saw

[paperenn]

Can anyone explain if they know how to change the drive belt on a Lurem 260C I combi saw 3 phase 3 motors, as I can see I may need to remove saw moter?, thanks if anyone can help ,the lurem machine is from the 80s and French no longer made

 

[Richard C]

My first post here, haven't introduced myself but will do that later.
I've a C360
3 phase, 3 motors.
But planer head and saw share same motor.
Is yours similar?
Assume yours has spindle moulder with own motor.
My belt for saw just slips off.
Have you a manual?
I'd be surprised you'd have to remove motor. Undo any tension.

I recently took the feed roller motor out and the belt slipped off when I slackened the motor in its mounting.

Probably not much help.

Just found this video and your model is very similar to mine.


Have you looked under the saw table with the insert taken out?
Lower saw blade.
Does that show the pulley? Is it on an open ended shaft?
My planer head has an open ended extended shaft and the belt just slips off.

 

[paperenn]

Can anyone explain if they know how to change the drive belt on a Lurem 260C I combi saw 3 phase 3 motors, as I can see I may need to remove saw moter?, thanks if anyone can help ,the lurem machine is from the 80s and French no longer made

Thanks for any help, it's done I found yo have to remove two bolts with a 13mm spanner on the left hand side of were the moter is fixed were you have the leave to raise and lower the saw, I will try and up loaded photos . Let you know in a few weeks when belts fitted and any problems. Other wise it was not possible to remove belt untill moter had been removed, but was easy, see how it all goes back together