BELT
- Thread starter BECKS
- Start date
Help Support UKworkshop.co.uk:
Smudger
Established Member
Scrit?
orangetlh
Established Member
either get in touch with Wadkin Ultracare with the model number, year of poduction etc, or take the belt of and take it to your local belt manufacturers. they will measure it and make one exacly the same, normally at a fraction of the cost of Wadkin
DomValente
Established Member
orangetlh":39ch5m05 said:
Would that be the shop next door to the blacksmiths or the one near the haberdashers ?
Dom
Chris Knight
Established Member
No, it's the one over the saggar makers and bottom knockers hall.
Not 5 minutes, but try a bearing supply company. V-belts are made by companies such as Ferodo and seel through bearing supply outlets and engineer's merchants, although another approach might be to replace the V-belt with link belt. I've had some of this sruff through a compressed air firm in the past (compressor drive belt replacement), but I can't find an on-line source in the UK
Scrit
Scrit
A
Anonymous
Guest
There's a company called All drives in Harlow, they supply all types of belts.
A belated additional piece of info - I had to adjust a v-belt on a machine this morning and noticed the name - Fenner. I should have remembered them as I've driven past their factory (warehouse?) enough times in the (dim and distant) past. Anyway they have a national distributors list with about 100 outlets here. They are worth making a note of as they also manufacture/distribute pulleys, flat belts, drive chains and sprockets.
Scrit
Scrit
timbar
Member
Fiveways Bearings will probably help you out, located in Eltham. www.fiveways-bearings.co.uk
