AGS10 Table Saw - Fence Guide Bar Spacing

[arborealstudio]

Hi All,

Just managed to get an original rip fence and rails for my AGS10 saw but unfortunately the spacers are missing. Looking at the manual the part number is A-1026/51 and listed as "fence slide bar distance piece".

I've taken some measurements from the rails and it looks like a plain cylindrical spacer with an OD of 20mm and an ID of 10mm would work. Not sure of required length for the spacers and was wondering if someone with an older style AGS 10 would be happy to take some measuremts of the spacer or of the distance between the guilde rail and the edge of the table bed. Have assumed it would be the same for the front and back rails.

Thanks for your help,
Eddie

 

[ManowarDave]

Morning Eddie,

Just dropped one off the saw and measured it. All four are the same.

Dave

 

[arborealstudio]

Hi Dave,

That's brilliant thank you - much appreciated.

Eddie