Search results

I have an MV12v...and made a 3/8" acrylic plate to insert to a table top...will the weight be sufficient to hold the unit in position or will it need to be fastened? Thanks for any advice.

Thanks marcros, a pic would help...I'm an BD9

The small table...approx. 12" square. I have the Elu version of this , but its dismantled. Does anyone have a copy of the manual I could have...postage paid. Thanks Gerry

...sounds like having a set of these wouldn't go amiss...replacing most used later for better quality. Thanks all for your views.

..anyone bought one of these router bit sets?... the ones that sell approx. 35 pieces for £35/£45 ..works out about £1 per cutter? ..any good?

Thanks Pete...worked a treat! ...now myfordman knows!!

...as above, any help please... struggling a bit with new OS!!

Having just restored my Lenovo desktop to factory conditions because it was sluggish (and saved all my work etc!).. my windows email won't start up!! The icon is showing on clicking the start button, but nothing happens when clicked!!? Running win 7. Help..anyone!

Thanks Glynne, CHJ and Steve. will report back!

I needed to remove the table from my newly acquired BS300 bandsaw. But on replacing it onto its four locations it is now out of square with the path of the blade!! (I removed the table to help transport and with the lifting!) The fence has to be offset by about 5/8" from front to back to get...

Thankyou ALL...just ordered from APTC... ...cheers Richard!

I'm interested in the above...wondered about any problems buying from the States!! Thanks for any advice. Gerry

I have been advised I can fit an extension to the immediate flue outlet..in the form of a pluming kit and reposition the flue outlet only. My flue outlet is 200mm ( 8" ) below the carport and is open at both ends and there is no obstructions opposite the opening. The message I received is as...

I need to extend the flue from my Unica 28 HE combi which is at the moment protrudes about 12" below my carport roof. ..condensation is the problem with water dripping from the pvc roof sheeting. Am I allowed to do this job, or do i need to have it fitted by Gas Safe? Thanks for any advice.

Is it absolutely necessary to use a special 'plunge' bit for routing a mortice? ...ie: where one of the cutter blades crosses the centre of the axis in order to 'scoop' out the middle of the 'cut'! ...have I described the correctly?

Can anybody recommend a car body repair service in the Bradford/Shipley area...first quote from Halfords ia £165 for a palm sized scuff at f/n/s wing. Thanks...

Latest from Inca... Thank you, Gerry - I will have a replacement bracket sent to you right away. Kind regards~ Linda

Hi dw, Incra have replied to my email...and fast!!...here is the reply. Hello, Mr. Stebbings~ From your attached photos, I believe the problem is with the fence mounting bracket. If you will provide your address, I will send you a replacement bracket. Please accept my apology for the...

Rutlands refuse to refund because the item has been used...I suppose I should have seen with my naked eye the discrepancy straight out of the box!!! ...perhaps I should have gone to spe*savers!!

I understand your thoughts craigy, but whilst cross cutting, I usually apply pressure with fingers forcing the timber to be cut, back onto the guide face , using this Incra fence it follows that it would want to tilt in order to make full contact with the face of the guide/fence! ..at the same...