Search results

Have you tried Record? http://www.recordpower.co.uk/support/pa ... es-service Best wishes

The 2nd set are High Speed Steel - the 1st are not stated, but even if they are only carbon steel, which is unlikely, they will be fine for Aluminium.

I merely suggested the hole saw way as an option. If Fishdesigns can obtain appropriate sized hole saws then it may work for him - or for anyone else that is reading these posts and has a similar job to do. It may be a cheaper route than buying a forstner bit or a bearing guided bit.

Yes - just dont go all the way through.

I have done something similar when cutting a hole for a metal insert to hold tea lights. I did it by cutting a 44mm hole with a hole saw then clearing it out using a trim router.

Taper the end of the stick and revolve the ferrule on the end to leave witness. The ferules are normally dirty inside which aids the process. Run a sharp knike around the stick to create a shoulder for the ferrule to register against. You can use epoxy or pin the ferrule. There may be a guide...

Does modifying the vac invalidate the warranty?

Looks like it might be swaged or worn out screwdriver slots.

By hand with a gouge?

Hi Did you see the results of the photos and videos that the others took, or are you assuming they were OK?

There is a reference to this on page 104 of post-a-photo-of-the-last-thing-you-made-t81798.html

As others have said - really nice dovetails. I looked at your Perfect Dovetails website - you have put a lot of detailed work into it. have you any plans to include a video of the method to give an overview? Thanks

... I love it.

I successfully adjusted the bolts that steer the lower wheel shaft on my EB 316. My issue was that, from getting the bandsaw secondhand and fitting a new Tuffsaws blace to it, the blade would not stay on the lower wheel during cutting - it just ran itself off under the load of cutting. Small...

Update I have reduced the 'run' to 0,2mm by resetting the thicnessing bed in the way SurreyHills described - see link in Bodger's post. I still have the option of using an MDF false bed if the situation changes. Thanks to ll that sent posts.

Why not post some of your efforts and see what suggestions you get to improve them.

What have other users of this machine, and similar ones, achieved - particularly in thicknessing mode. I have started to set mine up, having had it for several months whilst I cleared space to be able to operate it. I have read other 'setup' posts and decided to check what I could achieve in...

My previous post should have been addressed to Adam9453 too. Apologies.

AJB Temple The extension gained by this is 40mm, according to the description on the Axi website - which is more than for the XX and Musclechuck. Given that the body of the extension needs to be held with a spanner during toolchanging, does that mean that the spindle needs to be fully raised...

I have not seen any previous posts by you about your system, so could you update me to what it is that you have created. Thanks.