Search results

sorry to be so long the job grew i have had to buy a new switch as the overlod protection was in the motor so to be on the safe side ihave had to replace it so thankyou roy for your help in this matter much appreciated regards neil

hi roy i appreciateyour help .unfortunately i will not be able to experiment with the set up until the weekend cos at present i am working away from home.ill get back to you then ifs thats ok.thanks

roy the switch is still wired to the old motor and worked up untill i dismantled the thing so i meant it worked in that configuration is that what you were asking

yes

hi roy i havent bought one yet i will go wih whatever you suggest

5 and 6 are the terminals to the switch hope this makes things a bit clearer

hi again wing diagram of nvrI

roy the 4 wires inthe switch are + - and earth plus this 4th wire retuning from motor

ok roy iwill make a drawing tomorrow to post but as i said its the 4th wire i was some how hoping to use for the sensor then all the other wiring will be vitually the same i suppose

well im puzzled too.but im going to have to change the wiring on the swich somehow. because at the moment its wired to the old motor still in this 4 wire con figuration the switch is an aeg KS3 .its quite old butworks well also the terminals have no letters or nos.

hi roy the old motor that ive taken the switch from had the thermal cutout the new motor hasnt unless its completely internal thats what got me thinking i could wire in the light sensor somehow.

hi davel the sensor is being made for me by a guy at www.reuk.co.uk. its £16 inc postage he modified his design on the site for me using 1 metre wires on the led and sensor and adding a dc socket so i can power it with a plug top transformer .also changed it to turn off the relay rather than turn on

hi roy i have the sensor and an led opposite each other in the pipe just above the lid of the dustbin .as the bin fills it will block the the light and the sensor then turns on sending a 12v signal to the relay.the nvr is 16 amps all the wires to the motor and power in will stay the same but on...

hi george i think were at cross purposes here i dont think i explained it very clearly .i want to know if its possible to wire the 12vdc 240volt relay to the wire previously used by the themal cut out so that when the light sensor operates it will throw the nvr switch hope thats...

hi ihave recently finishe building a bill pentz cyclone and am attempt.ing to install a light sensor cut out switch.ihave a nvr switch from a schappach site saw which is man enough to run my 3hp motor .it has an extra wire which im pretty certain is for a thermal cutout in the old motor .my...