Mooeee
Established Member
Here is a set of hardware for a woodworking Bench/Table, I purchased these a few years back from Lie-Nielsen and had them shipped over, the side vice and tail vice are German made and I think these are what Lie-Nielsen used when making their benches, the handles are made from maple with cherry knobs attached using brass inserts and brass bolts, they have rubber O-rings at either end to stop the
handle banging against the vice when let go of.
The bench really needs to made around the design of these vices as I think it may be hard to incorporate them into and old bench.
Collection is required due to the shear weight of the vices, and would be from the Stevenage area about a Mile and a Half off of junction 6 of the A1M.
£380 for both vices Collection Only
£180 for Cherry/Maple Handles Collected, postage £6.95
handle banging against the vice when let go of.
The bench really needs to made around the design of these vices as I think it may be hard to incorporate them into and old bench.
Collection is required due to the shear weight of the vices, and would be from the Stevenage area about a Mile and a Half off of junction 6 of the A1M.
£380 for both vices Collection Only
£180 for Cherry/Maple Handles Collected, postage £6.95
Attachments
Last edited:
