I’ll watch it but im only try to set the right height so blades don’t catch table and shatter. It’s not easy to do when my hands turn 90 degrees outwards due to my disability but will watc it now. Had a look I can’t remo my table and all 5 or 5 nuts need to undue to adjust blades I’ve got what would be the pt200 the entry level and have tried that but cutter block is on a slight angle the blades sit higher on the cutting bit far side and there lower on side nearest you on on off button side. I’ve used wood a ruler engineers square but because it’s angled it’s hard to do that’s why I was asking of anyone had a old one or a one to one drawing so I could copy both arms.
