Moving on a little from learning to build cabinets to something not involving just a plunge saw.
My wife has some wooden sock blockers that are too large. I wanted to check my thinking on how to trim them to the correct size. I have a correct sized sock blocker so will use that to draw around on the over size one. Then cut with a jigsaw, and sand down to the correct size. Then use that as a template with a flush cut router bit for more sock blocks.
I’m not using a good sock blocker as a template on the assumption I’ll mess up in some way on the first go.
I’ll need to curve the edges a bit to stop snagging. It’s only 6mm thick so I was expecting to just hand sand that. Or are there tiny round over bits.
Finally, there are some more ornate versions online, see attached but I had no clue how to make all the internal cuts. Is it laser cut??
Pretty sure I can make it half as good for 10 times the cost!
My wife has some wooden sock blockers that are too large. I wanted to check my thinking on how to trim them to the correct size. I have a correct sized sock blocker so will use that to draw around on the over size one. Then cut with a jigsaw, and sand down to the correct size. Then use that as a template with a flush cut router bit for more sock blocks.
I’m not using a good sock blocker as a template on the assumption I’ll mess up in some way on the first go.
I’ll need to curve the edges a bit to stop snagging. It’s only 6mm thick so I was expecting to just hand sand that. Or are there tiny round over bits.
Finally, there are some more ornate versions online, see attached but I had no clue how to make all the internal cuts. Is it laser cut??
Pretty sure I can make it half as good for 10 times the cost!
