Record Power RPMS-R Router Table ( Thoughts )

[andypo]

Im thinking about getting one of these. Any Good? Any better alternatives for the money? Any body used one?
Cheers Andy

Link
http://www.screwfix.com/prods/65513/Pow ... uter-Table

 

[Rich]

Andy, did you read the review?

Rich.

 

[tsb]

Where do you find the review? I'm thinking of one as well.

 

[Chems]

A killer review. Really for 320 why would you bother buying one, why not make your own? It would only cost a fraction of the money.

But if you were going to buy a router table Id buy this:

link

Seen loads of really good reviews about it on different sites. Or its bigger brother, basically its got longer legs:

link

 

[seaco]

Friend of mine has one and it is sturdy but the fitting of the router underneath in my opinion is cr@p, plus you loose about 13mm between the router base and the top of the table.

The sliding part of the table wasn't level with the top and the fences sliding sides stuck all the time?

I think you'd be much better making your own or buying something like a Router Lift which is what he wishes now... Nuff said

 

[bluezephyr]

I have one, Mine was bought in February and didnt have the self raising stays on it that they seem to have put on now, but theyve given this and taken away something and replaced with plastic, I believe it was the extraction port.

Not bad, But not that brilliant, I have mine on a wheel base due to lack of room, Makes it so much easier for me, I have done a few jobs with mine but its permanently set up for one purpose unless i have to run of a load of beading and Getting to the chuck with a spanner isnt that easy.

 

[jonny boy]

I have the full iron top table model from Woodford and it's twice the machine for half the money! What more can I say.

jonathan.