Hi guys i'm really struggling, i'm making some french doors using a freud rail and stile set, I have cut the profie on the sides of the rails which are 600mm long. I keep the same setup in the router table (cutter at the same height etc) but as I run the long stile through the cut is always off centre.
When i do another test cut on a short piece of timber its fine. I am guessing the long lengths are tipping slightly or something, i have a feather board holding down and one pushing onto the fence.
i'm starting to question the router, or the jessem routalift its mounted in.
Any Ideas?
rog
When i do another test cut on a short piece of timber its fine. I am guessing the long lengths are tipping slightly or something, i have a feather board holding down and one pushing onto the fence.
i'm starting to question the router, or the jessem routalift its mounted in.
Any Ideas?
rog