Power Take off
- Thread starter DougT
- Start date
Help Support UKworkshop.co.uk:
I wired a socket into my table saw that the extractor plugs into, if you do it the otherway round you may be pulling too big a load through the extractor, most of the ones with a power socket on them are designed for hand held powertools.
If you want to spend a lot more and have the facility of overrun then Axminster do several options that will work with one or multiple machines
Welcome to the forum.
Jason
If you want to spend a lot more and have the facility of overrun then Axminster do several options that will work with one or multiple machines
Welcome to the forum.
Jason
Newbie_Neil
Established Member
Hi Doug
Welcome to the forum.
The cheaper option might be to fit a remote control. IIRC, they're about twenty pounds from Maplins.
In fact, here is the link. It's four receivers and one transmitter.
Cheers
Neil
Welcome to the forum.
The cheaper option might be to fit a remote control. IIRC, they're about twenty pounds from Maplins.
In fact, here is the link. It's four receivers and one transmitter.
Cheers
Neil
davy_owen_88
Established Member
Remember that you will have to disable the no volt release switch if your extractor has one, and in the process you may be removing the overload protection that is required on certain motors.
Also be weary of those remote control switches. If your extractor is particularly powerful or has an induction motor, the start-up current may be enough to fry the circuity - they were after all mainly designed for table lamps and other small loads. Don't be duped by the '13A switching capacity' either. That figure is often for purely resistive loads with no start up surge.
BTW, I'm not trying to turn you off the idea :lol: I have heard that some forum members use this type of remote switch and it works fine, but it really isn't a good idea on larger motors.
Also be weary of those remote control switches. If your extractor is particularly powerful or has an induction motor, the start-up current may be enough to fry the circuity - they were after all mainly designed for table lamps and other small loads. Don't be duped by the '13A switching capacity' either. That figure is often for purely resistive loads with no start up surge.
BTW, I'm not trying to turn you off the idea :lol: I have heard that some forum members use this type of remote switch and it works fine, but it really isn't a good idea on larger motors.
The remote control unit I have came in a pack of three or four from B&Q. The sockets are rated to work with loads of up to 3kW, so fine for the workshop vac on its own but I wouldn't want to switch the saw (2 kW Triton) and the vac on the same switch just in case the start-up surge is too much.
Hi Doug
I bought a remote from Euro batteries and it has worked fine for well over 6 months now. The extractor is tucked away neatly in the corner of my workshop and ducted to all my machines and can be switched on from anywhere with the flick of a switch
Phil
I bought a remote from Euro batteries and it has worked fine for well over 6 months now. The extractor is tucked away neatly in the corner of my workshop and ducted to all my machines and can be switched on from anywhere with the flick of a switch
Phil
My set is from Lidl, 4 3kW sockets and remote, (9.99). Been using for 2 year. The bit inside the controlled socket that does the actual switching is a small relay. The contacts on this will last best on resistive loads, like the workshop fan heater. A 3kW inductive load is really pushing it, so the dust collector starter is adapted so that the remote controlled socket only switches the starter pull in relay. Thus the starter still does the manful switching, and still provides overload protection.
