Parts for old coronet no 1 lathe

[macke]

I have an old coronet lathe and on the tail stock there is a washer that retains the handwheel. It's approx 55mm x 4mm thick and the centre is a 25mm u shaped slot. On strip down to refurbish this lathe I have lost it. Any ideas where I might get one anybody?

 

[dickm]

Not being funny, but it sounds like a job for hacksaw and file. Unless the Record version uses a similar part, in which case, they might be worth a try.

 

[Phil Pascoe]

Go to an engineering supplier or steel yard - see if you can get a washer about the same size and cut and file it to fit?

 

[Phil Pascoe]

Or contact https://www.lasermaster.co.uk/ - see if they can do you a stainless one, and cut the slot? Oddly, they're about a mile from where I live. Never heard of them before.