Kity 618

[Cub21]

Evening can any one help I have a Kity 618 saw but i am struggling to find information about the tee slots in the table top of the saw from reading posts I believe they are a none standard size which does make sense as when I have measured them they are smaller than what I have seen in catalogs and I have purchased a tenoning jig it Will not fit the slots in the. Kity
my question is does anyone know where I can buy or has anybody made the solid runner that fits the slots can any one help point me in the right direction please
regards cub21

 

[Lazurus]

My Scheppach also has non standard slots, wooden runners are a simple solution.

 

[marcros]

you can but some aluminium strip that is nearly the right size. it wont have the t shape.

check both imperial and metric sizes, but when I looked there was one that needed very little filing. Alternatively, hardwood runners would do the job.

 

[Cub21]

you can but some aluminium strip that is nearly the right size. it wont have the t shape.

check both imperial and metric sizes, but when I looked there was one that needed very little filing. Alternatively, hardwood runners would do the job.

Afternoon thanks for the reply can you remember where they were available from I have look and used oak strip but it does take some machineing it you want the tee putting in as well .

 

[marcros]

I did buy some years ago. I would think that it was likely to be from eBay.

 

[Phil77]

Hi I’ve just bought a Kity 618 table saw does anyone know where I can get a manual for it?

thanks

 

[Daniel2]

Hi I’ve just bought a Kity 618 table saw does anyone know where I can get a manual for it?

thanks

Kity 618 Manual

 

[Phil77]

Kity 618 Manual

Thanks very much