How'd I Do It?

[SketchUp Guru]

Here's a small challenge for the SketchUppers. Or is that SketcherUps? Or SketchersUp? Or... Oh nevermind. You know who you are.

 

[Neil]

Did you create an additional object oriented at 45 degrees to the sides of your stock, with the curved detail created using the bezier plug-in, then an 'intersect with model', then erase the cutting object?

Cheers
Neil

 

[Nick W]

Well, Dave, how did you do it?

 

[SketchUp Guru]

Alright, I'll tell.

Actually, I think Neil isn't really in Ireland. He must have been looking over my shoulder when I did it because he is correct. Even to using the Bezier tool to draw the curve. Good job sir. =D>

 

[Neil]

He must have been looking over my shoulder when I did it

Damn! Found out! :lol: Not sure about the tie you were wearing that day, Dave - a bit bright, wasn't it? :-s :lol:
Cheers,
Neil

 

[SketchUp Guru]

:lol: Maybe it was a bit bright but it squirts water out of the sunflower painted on it. :lol: