Alpha-Dave
Established Member
Ferm bench top pillar drill, 13mm chuck, 350w motor. Single phase.
5x speeds: 580, 850, 1220, 1650, 2650 rpm.
50 mm chuck travel.
I replaced the belt earlier this year as the original was juddery having been unused for a few years.
It will drill a 15.5 mm hole in 6 mm mild steel (biggest metal bit I had to hand), and 35 mm forstner in beech (again, largest to hand).
£60 collected from Durham.
5x speeds: 580, 850, 1220, 1650, 2650 rpm.
50 mm chuck travel.
I replaced the belt earlier this year as the original was juddery having been unused for a few years.
It will drill a 15.5 mm hole in 6 mm mild steel (biggest metal bit I had to hand), and 35 mm forstner in beech (again, largest to hand).
£60 collected from Durham.
Last edited:
