DW733 extraction

[jlawrence]

Hi,
I've picked up a cheap 2nd hand DW733 but it appears not to have the dust extraction hood. Can anyone who has one of these take some pics of the hood for me so I can fabricate one.

Jon

 

[9fingers]

This thread might give you some ideas

https://www.ukworkshop.co.uk/forums/view ... hp?t=20107

Bob

 

[jlawrence]

now that looks nice and straight forward. If it warms up a tad I'll have a play with it.

 

[jedmc571]

Jon

If you can wait till tomorrow, I'll photo the original 733 one for you.

Cheers

Jed

 

[Mr Ed]

Jon

If you can wait till tomorrow, I'll photo the original 733 one for you.

Cheers

Jed

Well done that man, I also have the 733 but it was a bridge too far to go out and start taking pictures of it at this time of night!

Ed

 

[Dalboy]

Don't know if this is of any help

http://www.powertoolspares.com/bd_model ... icknessers

You may get an general idea from the parts list

 

[jedmc571]

Hello Jon

As requested, Excuse the drawing Any more info let me know.

To confirm

Length 345
Height 53
Width 240
The lip with the centre hole is 10mm
From the opening at the mouth where the screws go through, this goes back 22mm and if you took a measurement from that point to the corner it would be 240, as in pic 2

Cheers

Jed

 

[jlawrence]

Thanks everyone.
Bit too cold here at the moment to get out to the shop. I'll fashion something together when it warms up a little.