chuck to fit a 19 mm dia motor shaft

[desmo11225]

Hello once again everyone
First of all thank you to who found the 25 mm square hole mortice chisel, I cannot find you again, this time does anyone know where we can purchase a chuck to fit our new motor ,which has a 19 mm diameter shaft .
I've hunted high and low locally as well but no luck . Once again thank you for all your help, I hope I can be of help to someone in the future. desmo11225

 

[Eric The Viking]

Are you sure of the diameter? 19mm is very nearly 3/4", so could it be an imperial shaft?

If so there ought to be a lot of options available.

Perhaps ask this in the metalworking section, but meanwhile have a look at Chronos's web site. They cater for many types of prototyping, including model makers, who often work in imperial. If you can't find something there, or eBay, possibly?

 

[desmo11225]

Thank's Eric
I spoke to a salesman at Chronus this morning and he was'nt helpful at all and I spent an hour on their web site yesterday ,they seem to have lots but I can't work it out on their web , that's why I came back to ukw , Chronus are only a few miles from me.
I also have tried to find someone who would make an adapter on a lathe for us but no luck so far. All the Best . desmo11225

 

[SkinnyB]

I used one of these on my Morticer:
Er collet for shaft 19mm. I ordered some brass shim stock as the fit wasn't 100%.

Not sure that's what you are after though.

https://www.aliexpress.com/item/3279412 ... b201603_52