chuck hubs

[chaoticbob]

Just ordered one. Now I have to think of a way of mounting it to the tailstock as well............

Assuming you don't need the chuck to turn when mounted on the tailstock and have an MT tailstock taper couldn't you just drill and tap a blank arbor M12 to take the male thread on your adaptor? The arbors in the link only go down to MT2, but MT1's are readily available if that's what you have.
I'm only an occasional woodturner, so apologies if I've misunderstood what you're trying to do.
Bob.

 

[Phil Pascoe]

Could you mount m12 nut into a board to screw it into?

Yes, I'll probably to down this route. I want to make a something I can tilt.

 

[Phil Pascoe]

Assuming you don't need the chuck to turn when mounted on the tailstock and have an MT tailstock taper couldn't you just drill and tap a blank arbor M12 to take the male thread on your adaptor? The arbors in the link only go down to MT2, but MT1's are readily available if that's what you have.
I'm only an occasional woodturner, so apologies if I've misunderstood what you're trying to do.
Bob.

Yes. It might be handy for it to be able to turn, but not necessary. That one had occured to me already.