Box joint jig for router table

[Mark18PLL]

Hi, been searching around for a simple jig to make box joints using a router table. Everything I find seems to use a table saw, which I don't have.

Any help appreciated.

Thanks
M

 

[DBT85]

I've not seen anything but since most just use a sled on the tablesaw and not the fence, making the same up for a router table should be fairly similar.

The one I saw on Fishers Shop on YouTube looked good and you could put different templates on it for different sized joints.

 

[Steve Maskery]

Tsk, tsk, you are not searching hard enough!
[youtube]eKEB-BIq9qI[/youtube]

Enjoy.

 

[RAF]

https://www.youtube.com/watch?v=nsgy6d4365k

10 minute youtube film. Don't know how to post the thumbnail like above. I've built two of these for 8mm and 12mm. Takes about an hour.

 

[Mark18PLL]

I obviously did not look hard enough, thank you very much