Asian stripe ebony box

[Bodrighy]

I'm not being picky George, just ignorant and curious re: threading. Is it possible to determinf where the thread begins and ends so that the grain matches or is that not really possible?

Pete

 

[cornucopia]

:lol: yes its very possible pete- but this box had already caused me allot of headaches so i didnt match this one up.

 

[stevebuk]

league of your own mate, i can only dream about it..

 

[Bodrighy]

I was watching someone demo thread chasing at the club and it looked easy...doesn't it always? Something that I'd like to be able to do but not for a while. Is this something that could be demoed at the bash or is it already full up with ideas?

Pete

 

[Paul.J]

Bodrighy wrote

Is this something that could be demoed at the bash or is it already full up with ideas?

I hope so Pete as i would like to see it been done.

 

[cornucopia]

No problem chaps i will bring my chasers with me- sods law though that what always goes smoothly in my own workshop will go **** up infront of people-

tom and richard come to play- i get a drill chuck stuck in my headstock!!! never happend before or since but i seriously thought it wasnt going to come out
Mark.s calls in for a coffe- I couldint get my tailstock to lock out!! allot of jiggleing later it finally goes in :roll: it always drops in smoothly!!!

anyway i'll have a go

 

[Paul.J]

Cornucopia wrote

No problem chaps i will bring my chasers with me- sods law though that what always goes smoothly in my own workshop will go **** up infront of people-

Nice one George.It looks like you will be busy

tom and richard come to play- i get a drill chuck stuck in my headstock!!! never happend before or since but i seriously thought it wasnt going to come out
Mark.s calls in for a coffe- I couldint get my tailstock to lock out!! allot of jiggleing later it finally goes in it always drops in smoothly!!!

anyway i'll have a go

Well look what happened when you came here George with my bandsaw :roll:
I think they say "it's sods law"