Applying Colorfill

[RogerS]

I've finally got around to filling in the damage done to my new laminated workstop due to overzealous upwards screwing....

The instructions seem to suggest just putting a bit on the spatula and then dragging it across the hole. Is that all? Does it need flattening/sanding down after drying? Wet and dry? I can see me making a pigs ear of this one

 

[jasonB]

Don't go near it with abrasive, you will just scratch the surrounding worktop. Apply with a flexible filling knife or spatula and strike it off level, remove any excess around the edge with a cloth dipped in the solvent/cleaner. It may sink as it dries in which case apply a second time.

Jason

 

[RogerS]

Thanks Jason. Told you I might have made a pigs ear

 

[engineer one]

no roger you cook the pig's ear, and just drag the filler across :lol:
:roll:
paul :wink: