Some pictutres from a recent table I made - would very much welcome comments on anything that you feel could have been done easier or better. The idea with the leg is to show off the wonderful end grain in this piece of pitch Pine
This was destined for land fill when I spotted in in a skip.
lots of nails and holes through it made it seem a difficult bit to get much out of.
Marked it up into discs so as not to get any nails or holes near the edges
and cut them all out
then glued them all up with a M12 rod through the middle - I want this leg to be thin-ish and the way the wood is cut makes me think it could be a bit snapable
This was destined for land fill when I spotted in in a skip.
lots of nails and holes through it made it seem a difficult bit to get much out of.
Marked it up into discs so as not to get any nails or holes near the edges
and cut them all out
then glued them all up with a M12 rod through the middle - I want this leg to be thin-ish and the way the wood is cut makes me think it could be a bit snapable
