Search results

I dont think Bob would say scrap it from all the help I've seen him give over the years. In fact I'm pretty sure he did a thread on his thicknesser which was a portable brush motored type. Your best bet would be to PM him so he gets an email notification, or post your question over on the...

Hi Yes it did work. I followed Pekkas advice. However this was a rustic outside project, would need some refinement to use for other things. No idea about the water stains Mark

Try a PM to him, which will land a notification in his email inbox if that's still in use Mark

He is called Ray Girling and used to post under the name Argee I think he has his own website if you google his name Haven't seen him post on here for ages Sorry cant help with the problem myself Mark

Nice work mark. What's going in the drawer? Mark

Other thing done was a full size drawing of the fence, which I needed to do in order to know where to route the t tracks. I've made good progress on the fence and will post some pictures soon Mark

Couple of other bits and bobs done Blocks screwed to the underside of the top to keep it in place This picture shows my original attempt at routing the hole for the plate, complete **** up. You might have spotted that behind the section in the base where the router hangs and behind the...

The worlds slowest router table build has been continuing. Next job was to continue to work on the top, router out for the t tracks, using a couple of guides. I had made the guides previously and they are slightly too short for the top, so i just routed a bit then slid the along and it turned...

Hi I've used m10 threaded rod in the past, works just as well as smooth round bars and can be had quite cheap on eBay Mark

Beech Did your fans come with speed control or is that something you rigged up yourself (and therefore an idea I could steal)? Mark

Hi Alsfords in Cobham usually have it in stock and have a panel saw to get it into manageable sizes Wey Plastics in New Haw will get it in and cut it up on their beam saw Im pretty sure any of the Champions will also get it for you HTH Mark

Charlie recently uploaded a vid showing how to make a variable width housing jig. Lots of other versions on the web Agree with wells wood, this is the best method Mark

Thanks Eric Progress has slowed but still continues, I have a few updates and will post when I have time Mark

I,ve now done all I can. Thanks for the link Andy, very informative. Am now thinking this is the valve playing up, time to find a washing machine repair man Cheers Mark

Its then just a case of clampingit to the top and router the hole I then realised I had routed too much of the corners away and had to stick a bit back on, doh :oops: Bare MDF sealed with paint i have fogotten to take a photo of the plate in the top Mark

I'm still building this but progress has slowed significantly due to holidays, work, other projects and watching too much olympics. I am still trying to do bits here and there though. I've cut the hole for the plate as follows. The plate is from Rockler and for the big Triton. First, the...

Hi When the machine tries to draw the softner from the drawer down into the drum it is not washing through the drawer properly. Water is certainly getting into the drawer but it doesn't seem to wash the comfort out leaving the drawer full of watered down comfort and not very soft washing. The...

Starting to wire it, involves another piece of ply to box in the back of the switch. Used the cable glands off the original plastic box to attack the wires Inside Back Connecting the switch up Rear of switch boxed in Output goes to a socket inside the table where the router will be...

Been meaning to post this for a while but been very busy and watching too much Olympics. I'ce been doing some work on the electrics. I started with one of these I then ttok it out of the back box and cut a ply face to hold it where the top right drawer would go Will look like this Its...

On current standings I find the American medals a bit of an eye opener. If you took swimming out of the Olympics they would be well down the table. Mark