Search results

I think it started when machines took over from hand tool work, They're also quicker and with a well set jig only setup requirement is depth of cut I did them for quickness I made that box in about 4 hours, if I'd done dovetails which I've only done on 2 pieces I've made so far it would have...

Wax/oil burner made from recycled copper pipe turned base from an off cut burnt and oiled

Not a manual but a very detailed strip down and restoration https://www.ukworkshop.co.uk/threads/multico-b2-planer-restoration-with-pictures.113265/

I use same method where sharpening gouges,didn't watch video

Depends how you fettle them and set them up These finger joints were done on a screwfix version of evolution rage 5s with an home made jig

I'm with Jacob on using 2 push sticks I like this style, I got a plastic one with a machine these are ply templates from it and cut out on scroll saw

I know sharpening threads on here can be contentious , but here goes I've never managed to get this bit working very well, any other chair/stoolmakers any experience of sharpening this Hearnshaw bros 1917 tapered reamer

If you have air bricks below floor level then cold air will come through every gap, you would have been better off putting an engineered wood floor down if you prefer the wood look

Beautiful wood and workmanship

Incense box and burner stand made from reclaimed bed leg and offcuts, burner stand made from reclaimed copper pipe, leather lining and pouch are reclaimed sofa leather Made for a christmas present

If it wasn't sheaved it's probably got a dot or 2 on cable fixing it to wall

Last plane I bought was a woden no 4 3 years ago .not bought another since to own , bought a few to restore and sell at nice prices, and i may thin herd of few what I don't really use that much but no I'm cured of my addiction

Table clamp vise, used to have a little record jewelers one, gave it away regretted it ever since

I'm not that bad only have about 25 planes at the moment, and don't intend adding many more

Lovely really nice work

It's a froe for riving wood

The 6 was repainted with paragons roundel blue The 5 1/2 is 1940s and original paint paint

Small Chest for granddaughter for art materials , made from recycled wardrobe doors

Screwfix sell threaded rod in both galv and stainless from 6mm to 16mm just checked only up to 1m any electrical wholesalers will sell 3m lengths of galv m10

Finger joint jig made from off cuts, made following steve maskerys youtube video, some test cuts in done in offcuts just need a litlle fine tuning 1/2 inch now set up pretty well