Search results

Option 6, love it.

I have a perform pt260 planer thicknesser (same as metabo/record power 260) and i want to know the correct process of how to adjust the thicknesser bed (not the planer beds). The chain that drives the four "pilar screws" that raise and lower the thicknesser bed came off, i got that reattached...

Hi I am building a shed/workshop and need some advice on the vapour barrier. I have been doing a lot of reading and realise the importance of a good vapour barrier but I am not sure where to place it in the floor layer. The shed is going to be built as a raised deck over a concrete slab using...

Thanks Dick M You were correct, there was a small amount of dust behind the support, propping it up a bit, I removed that and the feed in roller dropped about 0.5mm. This helped a bit but I needed about another millimetre. Also the out feed roller was very high and not contacting the wood at...

Hi guys New to this forum so apologies if this is in the wrong section. I have just bought a Perform PT 260 off ebay and I have an issue with the thicknesser feed. It seems the indeed roller is set higher (2-3mm) than the blade so that by the time I have raised the bed high enough to engage the...