Search results

Its connected in parallel so how can it reduce the current drawn does not make sense.

Try spray foam if the void is damp it will help the foam action like poly glue and it can take some movement .

What i have done is convert the socket feed into a ring main so it could deliver 32amp but fit a 20amp mcb then fit a 16amp socket to the ring main this set up has worked fine for 5years. This way you do not have to fit a new consumer box.

If the engine is free spin it over with the plugs out so no load for 10-15 secs then start it keep revs low when warmed set carb idle up This assumes new oil and petrol has been used and canister oil filter if fitted has been primed.

Armed with all the info above but still concerned about the irregularity of the vibes. i checked the mechanics to day and found the counter balance and drive pin output casting connection to the motor was loose, tightened the Allen key sorted.It still vibrates but its much smoother so thanks...

Thanks for the information gents that's put my mind at rest.

Been given a SIP variable speed fretsaw (same as axminster awvfs and jet jss-16) mounted on plywood base but it sounds strange not a consistent sound and it moves along the bench due to vibration varying the speed alters the amplitude of the vibs. max speed does not reduce vibration .Is this...

I have used t4 slimline linklite page 402 toolstation in our camera club colour print viewing unit with no complaints on colour temperature etc three sizes available recommended.

If the frames are fixed on the edge of the base and the cladding goes past the interface rain is shed clear of the base this design has worked fine for me i use treated timber for sole plate only on a dpc and cast in threaded rod with nut and washer as anchors. I also use breathable membrane...

Some high resistance may be, check connections and by pass on /off switch or check out with meter.

Try blowing the dust out of it and check for any stiffness or catching so the start up would be slowed.

12 months ago i had my heating re configured as the ground floor pipes were in the concrete slab so new piping from the upstairs to ground floor some radiators replaced. All old rads. washed out new pump cylinder and controls new tcv to all rads.new tanks and all new pipe work to new items. A...

Feed in tariff finishes 5-6 weeks i am told the price of the panel's will then reduce considerably so will it be worth it..

Treated timber need only be used where it may come in contact with damp so bottom wall plate /door construction . span is support point to support point . Remember a triangle is a strong structure so the birds mouth does not need to be over deep. Some American TV programs do code + 1 for timber...

I think the key to a great garage would be insulation (wall roof and base ) and a concrete slab design with insulation but also a strong floor just big enough so that rain is shed of the walls and not allowed to run under .You may like to use steel for roof support but its design would have to...

this mag may helphttp://www.pcpro.co.uk/latest-issue

The ones i tried find nails fine but not studs reliably.

I have the larger m/c and can adjust the height of the out feed table can you do this on this m/c.

This is a good site for roofing etc http://www.slecladding.co.uk/ and they do eaves filler good for draft proofing.

Switch every thing off and see if you are still spinning the meter then check the consumption of high users, immersion ,cooker etc you can get consumption meters that go between the plug and socket for the other appliances then you can determine if its your or the electric company's problem.