deema's latest activity

Just looked in the atelier, 'kin cold out there. Son has been tidying without telling me.. took me a while to find it..Two tubes ( to...

A small amount of variation from a motors rated speed isn’t really an issue. However, if an induction motor is rotated at a speed higher...

A few years ago I was doing a kitchen for a good friend , I had the mitre saw set up on the patio and I was cutting the pelmets . Ran...

3M do / did a sandable flexible body filler..I have an old tube in the outside atelier ( dark for looking for it here ATM to give you...

Before doing a repair are things still moving, a year should allow everything to dry and settle so is this movement down to settling or...

The skirting joints joints are mitred / scarfed. The house is dry, no leaks, no damp, no adverse humidity. The MRMDF was bought pre...

Last time I saw that mark I had fitted new skirts and ran out - I found an off cut that had been outside in the rain but most of it was...

Certainly looks to have blown the face of the MDF, slight bulging to the top of the moulding also. If the joint ends weren't sealed...

Hi, You need to use a filler that isn't water based, something like Ronseal(green tin) that is a resin type like car body filler, with...

If I’ve understood correctly you have tried a caulk fix on the skirting but it’s then shrunk again. It must reach a point where it...

Those painters should be thoroughly ashamed of themselves. There is one filler I like for this sort of thing called toupret tx 110. It...

I’m hoping that someone has a cunning solution to a problem I have. Just over a year ago, I remodelled a house I had bought, as part of...

There are only three things basically to cause the blade to wander. First is the gullets are not large enough to take the sawdust and...

As a (now retired) LPG operative, cutting rings and associated steel fittings are only used on steel / stainless steel pipe. Joints for...

I used to run two factories in China, one on Beijing and the other Nanjing. I think I had a really good insight into China. I’d suggest...