BarbaraT

If you don't notch them in, the planks end up longer than the intermidiate uprights on the front face ends up looking strange.. It's...

I can also put a chamfer with the plane along the back edge of the bottom beam so the water runs off. There replacing some very...

Depends how the gate is designed.. What about this.. The frame stays similar but has two extra uprights. (Blind moortice and tennon...

e Easier said than done.. My circular saw will only cut about 95mm, and the beam is 150mm high.. (100mm thick) I'd need the bottom...

Nearly.. I have 4.6m of stright fence next to one side of the gate.. I thought about it but It didn't quite work. You could reduce...

Sorry Amplidyne but what a load of Rubbish.. Should I hire a boring machine then and go down 100m, Anything deeper than 1.5m is a...

I already have the wood so the gate posts are going to have to be extened with concrete and steel happy to go down a meter This...

The posts are easy enough, I've bought some post savers, the soil is quite sandy so drains well. I could possibly run a thinner lower...

I building some big gates... 8m Span - 2.5m High I have about 600kg of oak. So there going to be big and heavy with Electric openers...

New tools arrived.

Will do

your father was probably far more skilled with a chainsaw than I am. I've just ordered a reconditioned Hitachi Chain Mortiser CA22 I...

I looked at the Axminster AP25bm, it looks like it will do 127mm with a 20mm cutter.. Almost deep enough, just expensive. And dragging...

I've got about 20 tenon joints to cut in some oak sleepers. Pockets Ideally to to go in about 150mm sleepers are (200 x 100) I was...