Chip shop
Established Member
phil.p":db0tp318 said:No sheet, Sherlock. :lol:
Don't dis me...I had to press a button, and everyfink :lol:
phil.p":db0tp318 said:No sheet, Sherlock. :lol:
custard":39obiho6 said:Aha! It didn't look like letter carving, but I've never seen a router template with a serif typeface. Hey, if it works then it works, the results are all that matters and the results look terrific!
OM99":3c70brro said:Tray made of oak and some pegs in the mitre to make them a bit stronger
ColeyS1":25fm31wu said:I bought a cast iron horse head to go on the face of my shed.
Coley
craigclavin":3uiym21v said:Hello all, I had some scaffolding boards left over from my garage build so I built a work bench...finished with polyx "terra" tints left over from the house renovation..
In essence it was free, and is jolly sturdy!
monkeybiter":3pg4rj8x said:Excellent result of an awful lot of hard work. I'd be far too lazy to leave the machines turned off.
xy mosian":v5id5281 said:As above, a couple of stools of european oak. Starting with two 30mm. thick boards everything else done by hand.
xy
Enter your email address to join: